Sunday, October 25, 2026

Flammability limits

Flammability limits 

·Lower explosive limit, LEL (also LFL) 

-The minimum concentration of vapor in air below 

which a spread of flame does not occur when the 

vapor is in contact with a source of ignition 

Acetone LEL=2.5% 

·Upper explosive limit, UEL (also UFL) 

-The maximum concentration of vapor in air above 

which a spread of flame does not occur when the 

vapor is in contact with a source of ignition. 

-Acetone UEL=12.8% 

·Explosive range (also flammable range) 

- The spread between the LEL and UEL 

- Acetone explosive range = 2.5-12.8% 


Relationship between toxicity and flammability


TLV ; PEL;  IDLH ; (LEL ; UEL) ; O2 deficient

1-100 ppm 1000-5000 ppm  (1-20 percent) 

Toluene Example: 

TLV=50 ppm, 

·PEL =200 ppm, 

·IDLH= 500 ppm, 

• LEL= 1.1%, 

·UEL 7.1%


Definitions 

• Ignition temperature 

- The temperature at which ignition (production of flame) and burning will be continued after the source of ignition or the source of heat is removed 

• Flash point 

-The lowest temperature at which enough vapor is given off near the surface of a liquid to produce a flammable mixture with air. 

• Flammable liquid 

- Liquids with a flash point below 100 F 

• Combustible liquid 

- Liquids with a flash point 100 F or greater


Fire Types 

• Flame fire 

- Gases or vapors 

- High burning rate 

• Surface fire 

- Burning rate may be slow 

• Explosion 💥 

- An event leading to a rapid increase of   pressure 


Explosions 

• Deflagration 

- Combustion wave propagates at subsonic velocity 

• Detonation 

- Combustion wave propagates at supersonic 

velocity 

• Gas or vapor explosion 

- Combustion of pre-mixed gas or vapor 

• Dust explosion 

- Finely divided solids, suspended in air

• BLEVE 

- Boiling Liquid Expanding Vapor Explosion 

- Flash evaporation after vessel rupture 

- May not involve combustion


Chemistry of Fire 

• Combustion 

- Rapid oxidation 

• Combustion components 

- Oxygen 

• Atmosphere (21%) 

• Chemical oxidizers 

- Fuel 

• Solids 

-Surface-to-mass ratio 

• Gaseous 

• Liquids (vapors) 

• BGases

•  Combustion components (cont. 

— Heat 

· Heat of combustion 

· Other sources of heat: (ignition) 

- Chemical reactions

• Decay 

• Slow oxidation 

- Electricity 

• Arcing 

• Resistance 

— Mechanical friction 

- Chemical Chain Reaction 

• Propagated by free radicals


Products of combustion 

· Heat 

· Acid Gases 

-Hydrogen Chloride

-Sulfur dioxide

·Soot, smoke

 ·Carbon dioxide 

 ·Carbon monoxide

- Incomplete combustion

• Nitrogen oxides 

·Ammonia 

· Acrolein 

·Hydrogen cyanide 

·Metal Fumes 

• Hydrogen sulfide 

·Phosgene


The Fire Triangle 

· Four components: 

- Oxygen 

- Heat 

- Fuel 

- Reaction 

• Removing any component stops the fire


Extinguishing a fire 

• Cooling - Applying water

• Removing Fuel 

- Shut off supply to gas or liquid fires

 - Pump liquid from burning tanks 

• Limiting oxygen 

- Mechanical smothering 

- Foam 

- Displace oxygen with inert gas

• Interrupt chain reaction 

- Capture free radicals using an extinguishing agent


Fire olassification 

Class A 

- Ordinary combustibles 

-Wood, paper, rubbish 

-Extinguish with water 

Class B 

- Flammable liquids 

-Water may aggravate a burning liquid fire 

-Extinguish with foam, chemical agents


Class C 

- Fires in electrical equipment 

- Use non-conductive extinguishing agent 


Class D 

- Combustible metal fires 

- Extinguish by smothering with dry powder 

- Water will cause burning metals to explode

• Special categories


Extinguishing agents 

• Water 

-Removes heat from a fire 

-Streams, spray or fog 

- Best for Class A fires 

- Not for electrical or combustible metal fires 

·Water mist may be used on electrical fires. These are special fire extinguishers, filled with distilled water, that produce a fine mist (no solid stream of water) 

·Foam 

- Excludes oxygen from burning liquid fires 

- Aqueous Film Forming Foam (AFFF) 

- Fire can re-ignite if foam breaks down

• Inert Gases 

- Displaces oxygen 

-Carbon dioxide, nitrogen 

• Halogenated Hydrocarbons 

- Inhibit chain reactions 

- HALON (bromo-fluoro-chloro-hyrdrocarbons) 

- Carbon tetrachloride (historically) 

- Ozone depleting 

– New, more ozone-friendly agents are available

• Dry Chemical 

- Inhibit chain reactions 

- Sodium or potassium bicarbonate 

-For Class B or C fires 

• Multipurpose Dry Chemical 

- Monoammonium phosphate 

- For Class A, B, or C fires 

- Excludes oxygen by coating surfaces 

• Dry Powder 

- Excludes oxygen from burning metal 

- Sodium chloride, graphite


No comments:

Post a Comment